![]() (Default = 0).ĭrain ohmic resistance (in Ohms). (Default = 1.0e-4)Ĭhannel-length modulation parameter λ (in 1/V). Transconductance parameter β (in A/V 2 ). The following is a list of parameters that can be stored in the associated model file: If no value is specified, the default value assigned to TEMP on the SPICE Options page of the Analyses Setup dialog will be used (Default = 27). ![]() Temperature at which the device is to operate (in Deg. Time-zero voltage across Gate-Source terminals (in Volts). Time-zero voltage across Drain-Source terminals (in Volts). Set to OFF to set terminal voltages to zero during operating point analysis. This setting affects a number of parameters in the model. Specifies the number of equivalent parallel devices of the specified model. ![]() To access this dialog, simply double-click on the entry for the simulation model link in the Models region of the Component Properties dialog. The following component-level parameters are definable for this model type and are listed on the Parameters tab of the Sim Model dialog. J SPICE Netlist Template %1 %2 %3 &"AREA FACTOR" &"STARTING CONDITION" ?"INITIAL D-S D-S VOLTAGE", G-S VOLTAGE"| Parameters (definable at component level)
0 Comments
Leave a Reply. |